Shell bracelet with macramé clasp

Instructions No. 1975

Instructions No. 1975

Difficulty: Beginner

Working time: 45 Minutes

Print instructions View material list

Material list

SunSummer, the sound of the sea .. in summer you show more free and Skin shells look particularly beautiful as an accessory. With our instructions you will succeed in creating a beautiful Bracelet made of Cyprea Moneta shells, which can be adapted to any arm by macramé knots. Because of the beautiful cards the bracelets are also very suitable as a gift idea for your loved ones.

This is how the beautiful things are Bracelet made:

Cut about 50 cm from the Cotton cord off. At about one third of the tape you start with a knot. The beginning of the threads will be needed later for the closure. Now thread the shells one by one and make a knot between them. For a good fixation Handicraft glue fill them with Sea shell something before. The if Cord necessary with a bamboo skewer in the Sea shell press. Release about one third of the tape at the end for the closure

The clasp of the bracelet is designed with 6 crossMacramé knots on each side. This allows the size Bracelet to be adjusted and also makes it easy to open and close. To do this, cut off another piece. Put it Bracelet together to form a circle so that the two ends of the thread are on top of each other.

Now place your loose thread under the thread ends and make a knot so that both thread ends are knotted. Tighten it well. You now have four tapes
Now proceed as shown in the diagram:

Nodes in detail:

The thread ends of the bracelet remain in place. Make a loop with the knotted left Ribbon one and guide the remaining thread over the two middle straps. Make a loop with the right Ribbon one as well, but this time the end of the thread is under the two middle bands. Pull the end of the thread from below through the left loop. Pass the left end of the thread through the right loop from above. Now tighten your cross knot. Continue with the knotting. Tighten the last square knot very well. Cut off the protruding threads. The best way is to fix it with glue or similar. Now the Bracelet size can be adjusted without problems

Close both ends of the band with a double knot

For the beautiful Gift wrapping cut this Kraft paper to size 10.5 x 7.5 cm. Cut about 0.5 cm in the middle on the left and right. Stamp the card and tie the finished bracelets around it.